![]() A network’s clients all point to a default gateway, which routes their traffic. A default gateway allows devices from one network to communicate with devices from another network. ![]() The first issue is assigning the default gateways to the end devices. ![]() Note that it will be Hermione’s Network instead of Sam’s Network in the above diagram.Ĭan you identify the issues with this implementation? If we try to implement this in Cisco Packet Tracer, we get something like this. Our reconfigured networks are depicted in the diagram below. Network administrators constantly configure and reconfigure networks. While we’re at it, we’ll reconfigure the other networks for our convenience. To resolve this problem, we must reconfigure the network. We cannot have an IP address where an octet is greater than 255. Each number in the set can have a value ranging from 0 to 255. IP addresses are expressed as a string of four numbers, such as 192.158.1.38. An IP address is a string of numbers separated by periods. There’s an issue with this configuration. One straightforward approach is to place a router between each network pair. To build large networks, routers must communicate with one another. You must now connect the three networks – yours, Hermione’s, and Ron’s. Hermione then went home and set up her own network. You connected your and Hermione’s networks to Ron’s network in the previous tutorial.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |